Laser Edge and Center Finder
GUARANTEED SAFE CHECKOUT
It doesn't get easier than this! With traditional edge and center finders, you need to back off from the original point and calculate the beginning point or the center point, but not any more. With the Laser Edge finder, simply chuck it up and align the laser with center punch mark or the edge of your workpiece or holding device. It can also be used in the lathe tailstock to align work in the 4-jaw chuck or to re-align the lathe tailstock after cutting a taper. The laser now comes with a polarizing filter to allow adjustment in the diameter of the laser dot. Start with a larger dot to make setup quicker then squeeze it down for greater accuracy. Uses three button batteries (D357H). On/Off switch is on the body to extend battery life. Can be used with 66-025, edge finder adapter, Shank diameters on the laser body may require a spacer. The laser now comes with a polarizing filter to allow adjustment in the diameter of the laser dot. Start with a larger dot to make setup quicker then squeeze it down for greater accuracy. Can be used with 66-025, edge finder adapter. Diameter of shank is 3/8". Shank diameters on the laser body may require a spacer.